Hoover DWOAD AH Series, Руководство пользователя

Страница: 14 / 28

14
l
To delay the start use the following
procedure:
- Select the required programme.
- Press the delay start button once to
activate it ( h00 appears on the display)
and then press it again to set a 1 hour
delay ( h01 appears on the display). The
pre-set delay increases by 1 hour each
time the button is pressed, until h24
appears on the display, at which point
pressing the button again will reset the
delay start to zero.
- Confirm by pressing the START/PAUSE
button. The delay countdown will begin
and when it has finished the programme
will start automatically.
l
It is possible to cancel the delay start by
turning the programme selector to
OFF.
If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme
and, when the power is restored, it
continues where it left OFF.
SOME MODELS are provided with the
automatic dosage, that carries out a precise
dosage of detergent and softener, up to 20
washing cycles*, providing a perfect
cleaning of your garments. This way water
and energy wastes are reduced, as the right
detergent and softener quantities are
perfectly to the milligram dosed, according
to the type of garment, to the weight of the
clothes and to the water hardness.
*
Estimate based on a medium load and a low water
hardness level.
The drawer is divided into three
compartment, as indicated in the figure :
A B
C
A = for LIQUID washing detergent
B = for softener
C = NO AUTOMATIC DOSING : for powder
detergent or liquid detergent with the
specific tray provided.
l
Pressing the CARE DOSE button you will
be able to set the autodose function,
according to your needs.
l
If you want to change the factory settings,
hold the
CARE DOSE button, until the
dedicated icons are blinking. Afterward,
you can choose the desired setting:
- Pressing once the CARE DOSE button,
the ONLY softener autodose will be
deselected .
- Pressing twice the CARE DOSE button,
both the detergent and softener autodose
will be
deselected .
The following options must be
selected
before pressing the
START/PAUSE button.
CARE DOSE button (AUTODOSE
SYSTEM)
WARNING:
The automatic dosing system can only
be used with LIQUID softeners and
detergents. IT IS FORBIDDEN to use
powder detergents or other additives.
Before using concentrated softeners,
dilute them according to the manufacturer's
instructions on the package.
The default setting for the autodose
system is set in the factory to carry
out both the detergent and softener
autodose.