CONTROLS AND INDICATORS
Control Panel and Indicator Lights
Programme
Selector
Acrylic Synthetic
Button
Anti-Crease
Button
Filter Care
Indicator
Program
Display
SELECTING THE PROGRAMME
Start/Pause
Button
Delay Start
Button
Empty Water
Indicator
Time Selection
Button
EN 9
Programme Selector
:
Time Selection Button
: To modify the drying timing of required programme; it works only
with certain programmes.
Delay Start Button :
To delay the start of the drying cycle and to dry your laundry when
electricity cost less ( please see dedicated section).
Acrylic and Synthetic Button
: When selected this indicator turns off and this new one
turns on; with this special function, the drying temperature is lower to better protect your delicate
clothes.
Anti- Crease Button :
Select the anti-crease function at the end of drying cycle. The drum
keeps moving at regular phases to refresh the laundry..
Cool down
: This indicator turns on during the final cool phase the cycle.
Start/Pause Button :
To start the programme required or to pause the cycle.
Automatic programmes :
Depending on desired programme, specific indicators turn on ( please
see programme list” ) ; ECO indicator turns on when you selected a low consumption
programme.
Filter Care indicator
When on, please clean the filters.
Empty Water indicator
When on, please empty the water tank.
“
Control Panel and Indicator Lights
The Sensor Dry machine gives many options for drying the laundry
to suit all circumstances. The table on the next page lists the
programmes and the function of each programme.
Note:
The sensor may not detect a small load of small articles. For small
loads and separate items or pre-dried fabrics with low moisture
content, use the timed programmes.
If the sensor does not detect the item the dryer will only operate for
10 minutes before going into cooldown.
If the load is too large or too wet to tumble dry the dryer will
automatically go into cooldown after approximately 3 hours.
In these cases we advise to use a time cycles between 30 and
75minutes depending on the load size and dryness required, and
select high or low heat depending upon the fabric type.
