HOW TO REPLACE THE
BOTTOM PLATE BRUSH
Disconnect cleaner from electrical outlet
and disconnect Powermatic nozzle from
extension wand.
1
Put the Surface Selector Lever in the
“Carpet” Position. This will allow for
easier removal of the brush. Turn
nozzle over. Remove bottom plate
by unscrewing the 2 Phillips head screws
at the back of the nozzle. Fig. 1. Lift plate
off to release from nozzle housing.
Turn inside of the bottom plate up. Care-
fully slide brush out of holders. Fig. 2.
With the Surface Selector Lever still in the
“Carpet” position, slide new brush into
holders one at a time supporting the holder
as you slide in the brush. Fig. 3. Center
brush in bottom plate opening by sliding
brush in holders as necessary.
3
Run a thin utensil such as a table knife
around the brush to make certain all the
bristles enter the slot in the bottom plate.
Fig. 4.
Replace bottom plate by fitting the plate
over the lip at the front of the nozzle hous-
ing. Line up the slots over the wheels and
position holes in bottom plate over screw
mountings. Fig. 5. Replace screws.
16
