Memory
The Wizard has 2 banks of 16 presets (A and B)
•
1-16A. Midi program change command 1-16
•
1-16B Midi program change command 17-32
Reverb
Press reverb button, dial in your reverb level , press rotary encoder short to save for the current
preset. Press reverb again to exit.
Cab
Press Cab button to go into cab menu. Select 1 of the 16 cabs. Press encoder short to save for
current preset. Press Cab button again to exit. If USB is connected to the wizard and the editor is
running, the cab knob is not functional.
Midi Channel:
The default midi channel is 1
To change the midi channel the Wizard responds to:
•
While amp is off, press rotary encoder and hold it.
•
Power amp on and release rotary encoder.
•
Cab and Reverb button are lit.
•
Select the midi channel by turning the rotary encoder.
•
Save by pressing 2 seconds.
Now your midi channel is set until you change it again.
Backpannel
Speaker load
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! ATTENTION !!!!!!!!!!!!!!!!!!!!!!! IMPORTATNT!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Use either a speaker cab and connect it to the right speaker output ( 4,8,16 Ohms )
OR
Set the load switch to ‘ON’.
It is not possible to use the LOAD and Speaker Cab at the same time.
If you use the amp without cab and load switch ‘off’ ,
you will damage your amp
!!!!
We advise to keep the master knob on the front panel
bellow 5
to keep the unit from generating
excessive heat and tube wear.
