Honeywell WTE-G-D-3.6-PT01, Руководство по эксплуатации продукта

Страница: 8 / 12

Malfunction Possible Cause
Solution
Low volume of
purified water
Irregular taste for
purified water
Raw water cannot
be fed
Filter cartridge is blocked
Volume of water exceeds ultra-
filtration cartridge’s capacity
Purifier is not cleaned
Filter cartridges not properly
installed and not tightly sealed
such that purified water is
mixed with potable water
Filter cartridge is blocked
Change the filter cartridge
Change the filter cartridge
Clean the purifier
Check whether the composite
filter cartridge’s gasket is
damaged, and install according
it in the correct manner
Change the filter cartridge
Composite filter cartridge
coagulates into blocks Shake the filter cartridge
Air inside ultra-filtration filter
cartridge not fully discharged Shake the filter cartridge or
prolong submersion hours
1 Counter
2 Troubleshooting
5
35
* Suitably adjust the filter cartridges’
replacement period based on the usage
volume of purified water and local water
quality.
* The composite filter cartridge has
undergone safety test by authorities
(disease control center). Furthermore
release of minute quantities of carbon powder during use is a normal
phenomenon and does not affect normal
usage
* Filtration of a container of water
requires roughly 15~20 minutes (for raw
water with a temperature of 25ºC; in areas
with poorer water quality, the filtration
period may be longer.)
1. Default setting: Press the “START” button on the counter for more than 3 seconds
until “00” is displayed, flashing on the screen. Press the “START” button again to
complete the default setting which is 35 days.
2. The display is on standby during normal use. Press “START” button to display the
remaining number of days. When the counter shows “00” the filter cartridges will have
to be replaced. Repeat the default setting operation after replacement of filter cartridges.
04 Maintenance and Repair
Caution