9
PROGRAMMING YOUR ST9500C
Exiting ZONE 1 Programming Mode:
To exit
ZONE 1
programming mode, move the slider to the
RUN
position. This can
be done at any time during the programming process, and any changes made and
confirmed with the button will have been saved.
Note:
If the unit is left in
ZONE 1
Programming mode for more than 10 minutes without the
slider being moved or any buttons pressed, the message ‘MOVE SLIDER’ will be displayed.
Press a button to finish programming, or move the slider to the
RUN
position.
Modifying the Zone 2 Programme
The zone 2 programme has three pairs of
ON/OFF
switching times per day. Each
time can be set between 3.00 am and 2.50 am (on the next day) to allow you to
programme zone 2 to stay on past midnight, if required.
a.
Move the slide switch to the
ZONE 2
position. ‘SET ZONE 2’ will show briefly to
verify this action.
b.
Now follow the same procedure to set the times as described in ‘
Modifying the
Zone 1 Programme
’ (page 7) steps
b.
to
i.
Exiting ZONE 2 Programming Mode:
To exit
ZONE 2
programming mode, move the slider to the
RUN
position. This can
be done at any time during the programming process, and any changes made and
confirmed with the button will have been saved.
Note:
If the unit is left in
ZONE 2
Programming mode for more than 10 minutes without
the slider being moved or any buttons pressed, the message ‘MOVE SLIDER’ will be
displayed. Press a button to finish programming, or move the slider to the
RUN
position.
Disabling / Enabling Time Periods
(for Zone 1 and/or Zone 2)
To disable any of the time periods
ON 1
to
OFF 1
,
ON 2
to
OFF 2
, or
ON
to
OFF
,
simply set the
ON
time and its paired
OFF
time to the same time, and the programme
will just ignore them.
To re-enable the time period, simply set the two
ON
and
OFF
times to be different.
ZONE 1
ZONE 2
DAY/TIME
ZONE 1
ZONE 2
RUN
