Honeywell Solaris 7980g, Руководство пользователя, Страница: 67 / 252

Solaris 7980g User Guide 53
Preferred Symbology Default
Scan the bar code below to set all Preferred Symbology entries to their default val-
ues.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the
Character Activation LED Timeout (page 3-54) is reached, the
deactivation character is received (see Deactivation Character on page 55), or a bar
code is transmitted. Scan the On bar code to use character activation, then use
Activation Character (page 3-53) to select the character you will send from the
host to start scanning. Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the
ASCII Conversion Chart (Code Page 1252) , page 224, find the hex
value that represents the character you want to use to trigger scanning. Scan the
following bar code, then use the
Programming Chart to read the alphanumeric
combination that represents that ASCII character. Scan Save to finish.
End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the LED can be
programmed either to remain on and scanning, or to turn off. When
End Character
Activation After Good Read is enabled, the LED turns off and stops scanning after
Preferred Symbology Default
* Off
On
Activation Character