Honeywell Solaris 7980g, Руководство пользователя, Страница: 55 / 252

Solaris 7980g User Guide 41
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the
Programming Chart , then scanning Save .
Serial Trigger Mode
You can activate the scanner by using a serial trigger command (see Trigger
Commands on page 186). When in serial mode, the scanner scans until a bar code
has been read or until the deactivate command is sent. The scanner can also be set
to turn itself off after a specified time has elapsed (see
Read Time-Out , which fol-
lows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scanner’s trigger when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner either by pressing the trigger or using a serial trigger
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay