Bluetooth Low Energy Scan Handle
Models SH-BLE-CT50, SH-BLE-75e
Quick Start Guide
BTLE-SH-MULT-QS-01 Rev A
6/16
*CT50-ND-MULT-QS*
Out of the Box
Make sure that your shipping box contains these items:
•
Bluetooth Low Energy (BLE) Scan Handle (SH-BLE-CT50 or
SH-BLE-75e)
•
Quick Start Guide
If any of these items are missing or appear damaged, contact your Customer
Account Representative. Keep the original packaging in the event that you
need to return the scan handle for service or if you want to store it while not
in use.
The BLE scan handle was designed to allow access to all of the buttons and
the touch panel of the mobile computer. You can use the mobile computer
inserted into the scan handle with the Scan Handle Holster. If you need to set
the mobile computer inserted into the scan handle down on a flat surface,
you can place the combination nose down.
The scan handle can operate under all of the same environmental conditions
as the mobile computer. The operating temperature is -20 °C to 50 °C (-4 °F
to 122 °F).
Caution: We recommend the use of Honeywell accessories and power
adapters. Use of any non-Honeywell accessories or power adapters
may cause damage not covered by the warranty.
Mise en garde : Il est recommandé d'utiliser les périphériques, les
cordons d'alimentation et les adaptateurs secteur conçus par
Honeywell. L'utilisation de tout périphérique, cordon d'alimentation ou
adaptateur secteur d'une autre marque est susceptible de provoquer
des dommages non couverts par la garantie.
Download and Install the Scan Handle Tool
You can download the Scan Handle Tool from the Honeywellaidc website at
www.honeywellaidc.com.
Attach the Scan Handle to the CT50
No special tools are required to attach the scan handle to the computer.
•
Slide the computer into the scan handle until it clicks firmly in place.
Attach the Scan Handle to the D75e
No special tools are required to attach the scan handle to the computer.
1. Press in on the rounded part of the release tabs on each side of the scan
handle base.
2. Slide the computer into the scan handle.
3. Press firmly on both sides of the scan handle locking bar to secure the
scan handle to the computer.
Scan a Bar Code with the Scan Handle
The scan handle makes it easy to scan a bar code with the computer. The
scan handle does not interfere with the ability to hear a beep on a good read.
•
Pull on the handle trigger to scan a bar code.
Remove the Computer from the Scan Handle
If you need to replace the battery, you will need to remove the computer from
the scan handle:
•
Press in on the bottom of both scan handle latches and slide the computer
out of the handle.
Replace the Scan Handle Batteries
There are two AA alkaline batteries in the scan handle that you will need to
change periodically.
