Honeywell REDLINK ERM5220R, Инструкция по установке, Страница: 9 / 60

9 33-00135EFS—07
Once power is connected, the “Compressor” (or “Boiler”) LED should
illuminate green. (Fig. 9)
Fig. 9.
7. For compressors and boilers:
Put the thermostat in pairing mode.
New thermostat installation: When going through the initial setup the
thermostat display will ask “TSTAT CONTROLS AN EQUIP MODULE”.
This refers to an EIM, not an ERM. See note below. The next screen
says “connect RedLINK Accessories?” The ERM is an accessory, so
select “yes”, and then “next”.
Existing thermostat installation: Select menu - installer options -
wireless manager - add device. See thermostat installation guide for
assistance.
NOTE: The ERM (equipment remote module) is not an EIM
(equipment interface module).
• If using a Prestige IAQ thermostat, the EIM (THM5421R) is
always needed, whether the ERM is used or not.
• If using a RedLINK VisionPRO model, the EIM is not needed
if:
(a) there are wire connections to R and C at the
thermostat subbase and the thermostat controls hot
water heat only (no cooling).
(b) the R and C as well as furnace or air-handler wires are
connected to the subbase of the thermostat.
8. Once the thermostat is in pairing mode, press and quickly
release the “Connect” button on the ERM.
OR
MCR35659
CONNECTED LED STATUS
Connect
Flashing: Device Connecting
Green:
Device Connected
Red: Not Communicating
Compressor
Boiler
Connected
MCR35660
CONNECTED LED STATUS
Connect
Flashing: Device Connecting
Green: Device Connected
Red: Not Communicating
Compressor
Boiler
Connected
33-00135EFS_D.book Page 9 Friday, September 8, 2017 1:59 PM