Honeywell Rapid Eye, Руководство администратора

Страница: 97 / 294

Rapid Eye Multi-Media DVR System Administrator Guide
Document 800-02953V4 Rev A 97
03/10
Using Many PTZ Domes/Cameras On One Serial Communications Iine
If more than one PTZ camera share the same serial communications line, make a note of:
• The address set on each camera.
• The driver needed for the make and model of dome. If the domes require different
drivers, they cannot share the same port/serial communications line.
Enabling a PTZ Camera
1. Continue or start a Maintenance Session for the Rapid Eye site.
2. Click the Video tab. Select the PTZ camera from the list of cameras.
3. Click PTZ (see Figure 6-2 ).
4. Select the Enable box. The PTZ boxes and the PTZ controller become available. The
Enable box is not available if a PTZ serial device is not assigned. To assign a PTZ
device, see
Assigning and Configuring a New PTZ Device on page 95 .
5. Select a driver that matches a PTZ camera. Drivers are listed in Table 6-1 .
6. If more than one PTZ camera is sharing the device, select a Camera Address that
matches the address set on the dome hardware.
7. Select the Port Attributes of the dome: Data Bits, Stop Bits, Baud Rate and Parity.
8. Select the position that a PTZ camera takes after a View operator closes a Live
Session. Consult your security officer before changing the When Live/Response Ends
value. See
Behavior of PTZ After a Session Closes and Table 6-2 , on page 103 .
9. Cameras that have a command menu can be set up using the Camera Menu button.
Use the dartboard control or the rubber band control to choose a command. Use the
Select button to change a value. The PTZ controls are explained in
Using a PTZ
Camera on page 98 .
Figure 6-2 A PTZ Camera Configuration Settings on the Video Tab
Select PTZ to
view PTZ
settings for a
camera
Set up
the PTZ
options