Honeywell Rapid Eye Hybrid LT, Руководство по установке

Страница: 58 / 86

58
Site Hardware
Consistent Port Attributes
Honeywell recommends that if domes are to share a serial communications line, installers
should select domes that:
•
Function at the same settings for: Baud Rate, Data Bits, Parity, and Stop Bits.
• Use the same PTZ drivers.
Caution Domes that require different PTZ drivers may not function as expected if
they are installed on the same port/serial communications line.
Configuring PTZ
Use the View application to run a maintenance session. Use the Video tab to configure PTZ
settings. Hybrid LT DVRs support the PTZ domes listed in
Table 5-3 . A Hybrid LT site can
support many types of PTZ software drivers at the same time. Refer to the Rapid Eye™
Hybrid HD and Hybrid LT Digital Video Recorders System Administrator Guide , for
procedures to enable a PTZ dome.
Caution After the installation, installers should communicate to the System
Administrator: each address used by the PTZ domes and the number of
the port used for PTZ on the Rapid Eye Hybrid LT DVR.
Table 5-3 PTZ Drivers for Controllers and Domes
Driver (name)
a
Baud rate Support for (dome/controller/PIT device)
Bossware 19200 PIT device, to which domes are connected
Honeywell fixed camera 9600 Honeywell HCU484
Intellibus
b
38400 ACUIX camera
Javelin 308 9600 Javelin 308 Controller
Kalatel 9600 or 2400 Kalatel KTD312 Cyberdome
Pelco D 4800, 9600, or 2400 Pelco D
Pelco P 2400 Pelco P
Rapid Dome/Orbiter 9600 RapidDome or Orbiter
SensorMatic RS422 4800 SensorMatic RS422: Delta and Speed
Ultrak (using VCL) 2400 Ultrak (configured as VCL)
Ultrak KD6 9600 KD6, HD6, HD6i
a
The drivers are not listed alphabetically in the View application. A driver can be used with
domes other than those listed. For other domes, controllers, or PIT devices, refer to the docu-
mentation provided with the device.
b
Intellibus protocol will be supported in a future release.