PRO TH3000 series
7
69-1929EFS—01
ENGLISH
10
0
Test
MCR29403
After completing the installer setup, press the
s
button again to begin a sys
-
tem test. Follow the procedure below to test the heating and cooling system.
1. Set
SYSTEM
switch to Heat.
2. Press
t
to turn on and check systems (see table, below).
3. Press
t
until systems turn off.
4. Set
SYSTEM
switch to
Em Heat
and repeat steps 2-3 above (
TH3210D only
).
5. Set
SYSTEM
switch to Cool and repeat steps 2-3 above.
6. Press and hold
ts
to terminate test at any time.
Installer system test
System switch
System test
number
System status
10
Heating system
0
Heat and fan turn off.
1
Heat turns on.
2
Auxiliary heat turns on.
20
Emergency heat
0
Heat and fan turn off.
1
Heat and fan turn on.
2
Auxiliary heat turns on.
30
Cooling system
0
Compressor and fan turn off.
1
Compressor and fan turn on.
70
Thermostat information
(for reference only)
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
System test
System status
Shaded areas below apply only to
TH3210D
.
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection is bypassed during testing. To prevent equipment damage,
avoid cycling the compressor quickly.
