Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
http://www.hls-nordic.com
Installation:
To install this luminaire, a hole Ø 70 mm must be cut in the suspended ceiling.
For correct mounting, observe
the light direction, use the corresponding lens retaining cover depending on the lens you will use.
A 5 lux lens (part no. 2900XX.STR)
is also available for order.
Step 1:
Put the lens on the retaining
cover.
Step 2:
Insert the cover with the lens on
the luminary. Be careful not to
touch the LED with your hand.
Step 3:
Unfasten the mounting screws,
A
for battery compartment and
B
for electrical connections.
Remove the respective covers.
Step 4:
Connect the battery and place the battery inside the compartment. Refit the cover and fasten the
removed screw (
A
) in step 3.
Step 5:
Connect the mains cables to the terminal blocks.
L
for live wire
N
for neutral. The ground terminal is
optional. The
C1
and
C2
terminals are used for elBus communication (optional), DALI communication
(optional) or voltage free contact (optional). After the connection of the cables, secure them with the
provided ties. Refit the cover (
B
) and fasten the removed screw in step 3. Place the main unit on the
false ceiling and follow the next steps.
Step 6:
Bend one spring, to get into the holes of the suspended ceiling.
Step 7:
Bend the other spring and push the luminaire upwards until it is securely mounted.
Step 8:
The device is now ready to operate. The TEST button is located next to the indication diodes.
Note:
In case of mains power disconnection for a period of more than two
months, the battery must be disconnected.
Dimensional drawings:
Ova/OmniLED R
Spot
GB
3
B
A
1
2
5
8
7
6
4
