OP Series
Issue 2
PK 88008
ADJUSTING ROLLER ARMS
The roller lever assembly is adjustable through 360° at
any of 1,980 positive lock positions at intervals of
approximately 0.2°.
To adjust the roller lever to the desired position, hold the
hexagon washer with a wrench and loosen lock nut
sufficiently to disengage the serrations. Hold shaft in
position by means of the hexagon washer so that no
torque will be applied to the internal parts of the unit
when the lock nut is tightened or loosened. Failure to do
so may result in damage to the enclosed switching
mechanism.
Moving lever one serration forward or backward with
respect to serrations on fluted washer changes the
position of the lever approximately 8.2° (see sketch on
page 3).
Moving lever and fluted washer, as a unit, one serration
forward or backward with respect to serrations on the
hexagon washer changes position of the lever 8°.
Moving the lever one serration in one direction, and the
lever and fluted washer, as a unit, one serration in the
other direction, changes position of the arm
approximately 0.2°.
After positioning lever arm, tighten lock nut sufficiently to
prevent slippage of arm, but avoid over tightening.
Excessive tightening will also deform the hexagon
serrated washer and cause lever assembly to bind.
STRAIGHT PLUNGER ACTUATION
Do not actuate by cams or slides
or by any other
device which will impart side thrust to the plunger. Use
straight "push" action in the direction of the plunger
motion.
Do not oil
this plunger mechanism. Sufficient
grease of the proper type is assembled in the plunger
during manufacture to last the lifetime of the switch.
Additional grease, oil, water or fine abrasive may cause
jamming or electrical failure.
REPLACING BASIC SWITCH
1.
Observe this notice:
Disconnect power supply circuit before opening switch.
2.
Remove cover of housing, disconnect the lead-in
wires, loosen screws holding the basic switch, then
remove the basic switch.
3.
Place replacement switch in the insulator, insert the
screws, and place basic switch in the housing.
4.
Tighten the screws and connect the lead-in wires.
5.
Be sure small compression spring is returned to its
position between the top of the basic switch and the
internal lever (or above internal lever in the case of
the CCW actuated switches).
MOUNTING DIMENSIONS
52,3
2.06
Roller Arm
Straight Plunger
One-way Roller Arm
Low Force Rod
Straight Plunger
Actuation
ELECTRICAL RATINGS
A
UL and CSA listed: L96
15 amps, 125, 250 or 480 VAC;
1/8 Hp, 125 VAC; 1/4 Hp, 250 VAC;
1/2 amp, 125 VDC; 1/4 amp,
250 VDC
B
UL and CSA listed: L23
20 amps, 125, 250 or 480 VAC;
10 amps, 125 VAC "L"; 1 Hp,
125 VAC, 2 Hp, 250 VAC; 1/2 amp,
125 VDC; 1/4 amp, 250 VDC
C
UL and CSA listed: L59
10 amps, 125 or 250 VAC; 0.3 amp,
125 VDC; 0.15 amp, 250 VDC
D
UL and CSA listed: L35
5 amps, 125, 250 or 480 VAC;
1/2 amp, 125 VDC; 1/4 amp,
250 VDC
2 Honeywell
•
Sensing and Control
