4 - 8
TD1166 rev1003
CONFIGURING THE NS1
The following steps describe how to configure the NS1.
1. Wake up the NS1 from sleep mode.
When powering up the NS1 for the first time, the NS1 is in the Installer sleep mode.
This programmer will automatically become the Installer Remote Programmer. It is
recommended to identify the Remote Programmer as the Installer by labelling it such.
Figure 3 indicates how to wake up the NS1.
1. Power on. (NS1 is in
Installer Sleep mode.)
2. Present a Remote
Programmer in the RF
field of the NS1.
3. Normal operation of the
NS1 is resumed.
Figure 3
Waking up the NS1
2. Set the Lock Type (23*).
Different lock types can be set by entering the key sequence corresponding with the lock type.
See the following table for information.
Lock Type
Key sequence
Description
Normally open
23*0*
Normally closed
23*1*
The settings “normally open” and “normally closed” are used when a lock
is directly connected to the NS1.
Coded signal
23*2*
Coded signal is used to trigger an external relay on the Connection Unit
(article NS1CU). The external relay offers a higher level of security.
The default value is 23*0*. To set another value, take the steps indicated in Figure 4.
1. Enter Program mode by
presenting Installer Remote
Programmer.
2. Enter the choice for the Lock Type, where
“n” is 1 or 2.
3. Normal operation of the
NS1 is resumed.
Figure 4
Setting Lock Type
