Honeywell N86 Series, Руководство пользователя

Страница: 45 / 218

3 - 7
slightly less range than Normal mode. Enhanced mode is best used when you
require a very fast scan speed and don’t require a long working range.
Default
= Manual Trigger-Normal.
Serial Trigger Mode
You can activate the scanner either by pressing the trigger, or using a serial trig-
ger command (see
Trigger Commands on page 10-4). When in serial mode,
the scanner scans until a bar code has been read or until the deactivate com-
mand is sent. The scanner can also be set to turn itself off after a specified time
has elapsed (see
Read Time-Out , which follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scanner’s trigger
when using serial commands to trigger the scanner. Once the scanner has
timed out, you can activate the scanner either by pressing the trigger or
using a serial trigger command. After scanning the
Read Time-Out bar
code, set the time-out duration (from 0-300,000 milliseconds) by scanning
digits on the
Programming Chart inside the back cover, then scanning
Save .
Default = 30,000 ms.
* Manual Trigger - Normal
Manual Trigger - Enhanced
Read Time-Out