Honeywell MILLER Soll-MultiRail 17792, Инструкция по эксплуатации и техническому обслуживанию

Страница: 6 / 16

T49/92 81/83 02-0, T49/92 81/36 26, soell@sperianprotection.com
Sperian Fall Protection Deutschland GmbH & Co. KG, Seligenweg 10, D-95028 Hof
Safety in Action
C Using the glider
The Söll anchorage device should be used only by personnel who are
trained to handle this device safely. Every user must use a separate
glider!
Fit the EN 361 safety harness in accordance with the applicable
instructions.
If using:
• a safety rope with EN 355 fall arrester, attach this to the back eyelet of
the safety harness in accordance with the instructions.
Important!
The fall arrester must always be on the body side!
• a travelling fall arrester with flexible guide, use only equipment that the
manufacturer has guaranteed will also function in the planned direction
of strain.
Attention!
The glider is to be inserted in the guide rail and the user may attach to
the glider only when he is in a position secured against falls. Before
removing the glider or detaching from the lanyard, (safety line, guided
type fall arrester) safety against falls has to be otherwise provided.
11
D Maintenance
D 1. The regular maintenance of the "Söll-MultiRail glider" are to be
performed considering the legal regulations, the conditions of use and
environmental conditions. Maintenance must be performed by a
compentent person, at least once a year.
A competent person for the maintenance of this equipment is
a person suitably trained or qualified by knowledge and practical
experience to enable the maintenance to be performed properly.
D 2. Regular maintenance is essential as the safety of the operator
depends from the effectiveness and durability of the equipment.
D 3. Maintenance checklist (see fig.5)
The checklist has to be completed and signed by a competent person
by means of an indelible pen.The single check points have to be
marked respectively with "OK" or "D" (defect) .The competent person
is responsible for the accuracy of the information provided therein.
Check points marked with a "D" can be corrected by a competent
person only when the defect to be corrected concerns the removal of
dirt (paint, mortar, concrete) or when markings need to be cleaned.
This procedure must be noted in the annex of the check list (remarks),
complete with date and signature of the competent person. The due
date of the next regular inspection must also be indicated.
In case the correction of defects requires a partial disassembling of the
components, the "Söll-MultiRail glider" must be returned to the
manufacturer together with the manual and with a relevant comments
concerning the defect.
6
www.honeywellsafety.com