MCV2000 SERIES HYDRONIC VALVE
Honeywell Co., Ltd.
Environmental Controls
18F, Kukje Center Building 191, Hangangro-2ga,
Yongsan-gu, Seoul, 140-702, Korea
Tel. 82-2-799-6170/6194
Fax. 82-2-799-6188
ENS5001R2 KO06 2005
4
INSTALLATION
1. The valve may be plumbed in any angle but
preferably not with the actuator head below the
horizontal level of the valve body. Make sure there is
enough room around the actuator head for servicing
or replacement.
2. The valve body can be mounted directly onto the
inlet pipe. Mount the metal flange inserted in socket
to outlet pipe. And then tighten the socket enough to
make a seal. See Figure 2 for the detail dimension.
3. Mount the valve directly in the tube or pipe. Do not
grip actuator head while making and tightening
plumbing connections. Either hold valve body in your
hand or attach adjustable spanner across the
hexagonal or flat faces on the valve body.
WIRING DIAGRAM
Fig. 3 Diagram with 3-wire Actuator for SPST Controller
Fig. 4 Diagram with 3-wire Actuator for SPDT Controller
CAUTION
Disconnect Power Supply before making electrical
connections to prevent electrical shock and equipment
damage.
WARNING
Take care that installer is a trained experienced service
person.
When installing this product:
Read these instructions carefully.
Failure to follow them could damage the product or
cause a hazardous condition.
Check the ratings given in the instructions and on the
product to make sure it is suitable for your application.
Always conduct a through checkout after installation.
BLACK
SPST Controller
WHITE
L
N
NO
RLY
NC
GREEN
MCV2000 Series
(CLOSE)
(OPEN)
SPDT Controller
NC
NO
BLACK
WHITE
GREEN
MCV2000 Series
L
N
(CLOSE)
(OPEN)