Honeywell JOSI-DBC012-N11, Руководство по установке

Страница: 17 / 40

ACUIX
TM
Fixed Dome User Guide
Document 800-01605 Rev A 17
04/08
1. Select the location of the housing. Each ACUIX™ Fixed requires either a 17 to 28
VAC or an 11 to 16 VDC power source measured at the housing. Each ACUIX™
Fixed has a power consumption of 3.5W for the color cameras or 4.5W for the WDR
cameras. Ensure a 24 VAC/12 VDC @ 0.2A power source is available. See
Appendix B, Cable Guidelines on page 35 for maximum wiring distances to the
dome.
2. Remove the ceiling panel at the dome location.
3. Place the ceiling tile on the dropped ceiling plate. Trim the ceiling tile so you can
press the ceiling tile into the dropped ceiling plate.
4. Cut a hole in the ceiling tile flush with the hole in the center of the plate.
5. If necessary, secure a safety cable (supplied by the installer) to a building support
structure. Honeywell recommends using a 3/32” plastic coated aircraft cable.
6. Insert the housing in the ceiling
a. Adjust the turning screws on the wing tabs to ensure the space between the
wing tabs and housing flange is greater than the thickness of the ceiling.
b. Position the wing tabs flat against the housing. Insert the housing through the
hole in the ceiling tile. Using a Phillips screwdriver, turn the two screws in the
housing clockwise to rotate the tabs out and tighten the tabs against the ceiling
tile. The recommended maximum torque is 1–1.25 N-m or 0.74–0.92 lbf-ft or
8.85–11.06 lbf-in.
c. Insert the housing through the hole in the ceiling, ensuring the wing tabs are flat
against the housing. The recommended maximum torque is 1–1.25 N-m
7. See Connecting the Cables on page 20 for information on connecting the field
wiring to the interface board in the housing.
8. See Installing the Camera Assembly on page 21 for information on installing the
camera assembly and Installing the Lower Dome on page 23 for information on
installing the lower dome.
In-Ceiling Housing Installation
WARNING! Installation must be performed by qualified technical
personnel and must be in accordance with all national and
local mechanical and electrical codes.
Perform the following steps to install an ACUIX™in-ceiling housing:
1. Select the location of the housing. Each ACUIX™ Fixed requires either a 17 to 28
VAC or an 11 to 16 VDC power source measured at the housing. Each ACUIX™
Fixed has a power consumption of 3.5W for the color cameras or 4.5W for the WDR
cameras. Ensure a 24 VAC/12 VDC @ 0.2A power source is available. See
Appendix B, Cable Guidelines on page 35 for maximum wiring distances to the
dome.
2. Cut a 7/15-16” (201.2 mm) diameter hole in the ceiling.