Honeywell HRSD40F, Руководство пользователя

Страница: 30 / 168

30
HRSD40F DVR User Guide
Factory Reset
The DVR has a Factory Reset switch to the left of the Network port on the rear panel.
Use this switch only on the rare occasion that you want to return all the settings to the
original factory settings.
Caution When you press Factory Reset , you will lose any settings you
have saved.
Figure 2-8 Factory Reset Switch
To reset the unit, you will need a straightened paperclip:
1. Turn off the DVR.
2. Poke the straightened paperclip into the unlabeled hole to the left of the Network
port (see Figure 2-8 ) and then turn on the DVR.
3. Hold the reset switch down until the DVR turns on and the live monitoring screen
appears.
4. Release the reset switch. All the DVR settings return to the original settings it had
when it left the factory.
Connecting to the Network Port
The DVR can be networked using the 10/100Mb Ethernet connector. Connect a CAT5
cable with an RJ45 jack to the DVR connector. The DVR can be networked with a
computer for remote monitoring, searching, configuration, and software upgrades. See
Chapter 3, Configuration for configuring the Ethernet connections.
Figure 2-9 Network Connector
Factory reset switch
N E T W O R K