Honeywell HCX13MW, Руководство оператора

Страница: 29 / 48

HCX Series Network IP Camera Operator Guide
Document 800-01794 Rev C 29
05/09
Network Setup
Figure 1-15 Network Screen
Use the Network settings screen to configure how the camera operates during TCP/IP
connections. You can adjust your camera's initial configuration settings. Changing a
setting immediately sends an activation command to the camera. While the command is
being sent, you may not be able to change other settings.
Table 1-5 Network Settings Fields
Field Description
Name Specify the name of the camera
IP address Specify the IP address of the camera. This will not take effect until
the camera is rebooted.
subnet mask Specify the subnet mask, or netmask, that the camera should use.
IP networks can be divided into several smaller networks by
subnetting. When a network is subnetted, you must specify a
subnet mask which tells network devices which smaller network
they belong to.
Note If the subnet mask is not properly configured, the camera
may not be able to communicate with other devices on the
network.