www.honeywell.com/security
+1 800 323 4576 (North America only)
https://www.honeywellsystems.com/ss/techsupp/index.html
© 2014 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written
permission from Honeywell. The information in this publication is believed to be accurate in all respects. However, Honeywell cannot
assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change
without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
Document 800-16667 – Rev A – 01/2014
5. Connect the camera wiring. Refer to the quick installation guide that came with the camera
for details.
6. Access the camera’s browser-based viewer (Honeywell Viewer) to view images, or,
alternatively, connect a coaxial cable from a portable service monitor to the BNC
connector on the camera control board.
7. Adjust the pan and tilt setting of the camera as desired. Loosen the locking screw on
the camera assembly gimbal to adjust the tilt angle and then retighten it. The tilt angle
is adjustable between –10° and 90°. The pan adjustment range is nearly 360° and the
rotation angle range is nearly 270°.
8. If you connected a coaxial cable to the camera in
step 5, remove it.
9. Replace the inner cover on the camera assembly.
10. Reinstall the screw securing the camera
assembly to the camera base.
11. Replace the dome cover on the camera base.
12. Tighten the two captive security screws on the
dome cover using the supplied Torx key.
13. Align the three holes in the trim ring with the
retaining nut on the in-ceiling mount, and then
snap the trim ring in place to complete the
installation.
