© 2016 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be accurate in all
respects. However, Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new additions to this publication
may be issued to incorporate such changes.
MicroSD card slot
Figure 2-1
Figure 2-2
Figure 2-3
Before You Begin
Before you begin, check that you have received all of the parts listed below. If any
parts are missing or damaged, contact your dealer immediately.
•
Camera
•
Installation CD
•
Quick installation guide
•
Allen key (L-wrench)
•
Self-tapping screws (×4)
•
Plastic wall anchors (×4)
•
Mounting template
Required tools
•
Phillips screwdriver
•
Drill with appropriate bit for pre-drilling wall anchor holes
CAUTION
Installation and servicing should be performed only by qualified and
experienced technicians to conform to all local codes and to maintain your warranty.
Preparing the Mounting Surface
1.
Inspect the site where you want to install the camera. The mounting surface
must be flat and capable of supporting at least three times the weight of the
camera.
2.
Remove the backing from the mounting template sticker and affix the sticker to
the mounting surface.
Note
If you are using the side exit for the cable, note
the orientation of the cable exit notch. In outdoor
installations the notch should point downwards to
prevent water from entering the camera housing.
3.
Drill three screw holes at the locations indicated on
the mounting template sticker and insert the three
supplied plastic anchors in the holes.
4.
If you are flush mounting the camera and want to
store the cables inside the wall or ceiling, drill a
hole at the cable exit position on the mounting
template and then pull the cables through the hole.
Mounting the Camera
1.
Use the supplied Allen key to remove the dome cover from the camera assembly
and set it aside.
2.
If local storage is needed, insert a microSD card into the microSD card slot as
shown in Figure 2-1.
3.
Connect one end of the Ethernet cable to the RJ-45 port on the camera.
4.
If the other end of the Ethernet cable is NOT connected to a PoE switch or NVR,
connect the power connector of the camera to a 12 VDC power source.
5.
Attach the camera assembly to the mounting surface using the supplied screws.
Aiming the Camera and Logging On to the Camera
1.
Aim the camera lens in the desired direction as shown in Figure 2-2 and Figure 2-3.
Note
Lens adjustment can be divided into left/right and up/down adjustment.
Left/right adjustment can be done manually as shown in Figure 2-2. For up/down
adjustment, you must insert the L-wrench into the hole on the lens and turn it as
shown in Figure 2-3.
2.
Tighten the adjustment screws to secure the camera lens in place.
3.
Reattach the dome cover.
4.
If the camera is connected to the PoE port of a Honeywell Embedded NVR, you
can log on to the camera directly from the NVR. To log on from a PC:
a.
Install the Honeywell Config Tool from the installation CD.
b.
Use the Config Tool to discover the camera and open the camera’s
webpage.
c.
Log on to the camera as the admin user. The default user name is admin
(case-sensitive) and the default password is 1234.
Note
Only Internet Explorer 11 and Firefox 46.0.1 (or later) browsers are supported.
(North America only)
(Europe only)
(Asia Pacific only)
Document 800-22215 – Rev A – 06/2016
