Performance Series IP Camera Software Configuration Guide
4
Figure 2-1 IPC Tool
Assigning a New IP Address to Your Camera
The current IP address of your camera appears in the
IP
column of the devices list. If you
want, you can assign a new static IP address to the camera.
To change the IP address of a single camera:
1.
Select the camera that you want to configure from the devices list.
2.
Click the
Network
tab.
3.
Clear the
DHCP
check box.
4.
Enter the new IP settings in the
IP Address
,
Subnet Mask
, and
Default Gateway
fields.
5.
Click
Apply
to apply the settings.
To change the IP addresses of multiple cameras at the same time:
1.
In the left-most pane of the IPC Tool utility, click
Batch Setting
.
2.
Select all the cameras that you want to configure from the devices list.
3.
Click the
Network
tab.
4.
Do one of the following:
•
To assign dynamic IP addresses, select the
Set all to DHCP
check box, and then click
Apply
.
•
To assign static IP addresses, enter the settings in
IP Range
,
Subnet Mask
, and
Default Gateway
fields, and then click
Apply
.