How to Change the Filters...
The only three parts requiring any service are the activated carbon
pre-filter, the CPZ™ filter and the HEPA filter. No tools are needed. To
change either filter, disassemble the unit as shown.
1. Loosen the carrying handle by turning it counterclockwise and lift
filter cage cover from unit.
2. Lift HEPA filter, CPZ™ filter and activated carbon pre-filter from
the base.
3. Remove the fasteners from the activated carbon pre-filter and
remove
it from the HEPA filter cartridge.
4. Replace filter(s) as needed, and discard used filters.
5. Wrap the activated carbon pre-filter around the HEPA filter
cartridge and secure it with the fasteners provided.
Reassemble your
Honeywell
air cleaner as described below:
1. Place the assembled HEPA filter, CPZ™ filter and the activated
carbon pre-filter on the base.
2. Replace the protective screen and lid.
3. Reattach the carrying handle and turn it clockwise until securely
tightened.
;;;
;;;
;;;;;;;
;;;;;;;
;;;;
;;;;
;;;;
;;;;
;;;
;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;;;;;;;;;;
;
;
CAUTION: DISCONNECT FROM POWER SUPPLY BEFORE SERVICING
•
Check to make sure that the power cord is correctly connected to the outlet.
•
Test the outlet with another appliance or lamp.
•
Check the fuse or circuit breaker. The outlet may be overloaded if other appliances
are also in use. Determine and correct the cause of sthe overload.
•
If none of the above procedures restore operation, return your unit to the store or if
the store's return policy does not allow, return the complete unit per the
instructions in the warranty section of this owner's guide.
Do not attempt to repair
the unit yourself.
If the Air Cleaner Does Not Operate...
