DT70 FAN -COIL THERMOSTATS
EN1001R0 KO06 2000
3
23456738
The DT70 Series thermostat is the temperature control element
in the fan-coil or air-conditioning system, and must be located
about 1.5m above the floor in a position with good air
circulation at room temperature. Do not mount it where it could
be affected by :-
-
draughts or dead spots behind doors or in corners
-
hot or cold air from ducts
-
radiant heat from the sun or appliances
-
unheated (uncooled) areas such as an outside wall
behind the thermostat
-
concealed pipes or chimneys
)0&"/22/")+0
93:8678;%6<=%6<=>?3@656
The DT70 Series thermostat can be directly mounted on the
wall or on either a 65x65mm standard junction box or a
85x85mm junction box. Mounting screws are supplied for both
alternatives.
IMPORTANT
The installer must be a trained service engineer
Disconnect the power supply before beginning installation
•
!
Separate the base
from the main unit
•
!
Base mounting
•
!
Wiring
•
!
Carefully insert the
main unit on the base
Fig.2. DT70
Mounting
Twist
!
driver into the
hole at the bottom of
main unit
Mount the base on the
junction box with the
screws supplied
!
Pull out wires through
the square hole of base
"
Wiring on the back of
main unit
