4
Charging
Use only the Li-ion battery packs provided by Honeywell. Use of any battery
not sold/manufactured by Honeywell may result in damage not covered by the
warranty.
The Net Base charges the main battery of each terminal in less than four
hours. The intelligent battery charging system incorporated into all
Dolphin terminals prevents overcharging, which means that Dolphin
terminals may be stored in the Net Base indefinitely without damage to
the terminals, battery packs, or the Net Base.
1.
Install the Li-ion battery pack into the back panel of the terminal.
2.
Slide the Dolphin terminal into one of the terminal wells until the
Dock LED lights solid green. Charging begins immediately.
Connecting the Dolphin Terminal to the Net Base
After the Net Base is installed, configured, and connected to the host
computer, you must connect the Dolphin terminal to the Net Base.
1.
Insert a Dolphin terminal into a terminal well.
2.
On the Dolphin terminal, tap
Start
>
Power Tools
>
RASMan
. The
RASMan utility initializes.
3.
When the connection is established between the Dolphin terminal
and the Net Base, the terminal plays a sound and the
communication icon appears in the Navigation bar.
4.
Upon connection, the Dolphin terminal is assigned an IP address
from the Net Base, which can be used by any application on the
Dolphin terminal.
5.
When you exit RASMan or remove the terminal from the Net Base,
the terminal plays a sound and the disconnected icon appears in
the Navigation bar.
!
