4
5
6
7
Installing CloudLink 4G M1 Modem in MiWireless as example (pivot panel)
1
2
3
EXT
-PWR
COMMON
EXT
-PWR
COMMON
4
Position the mounting tabs onto the slots of the
bracket and torque the captive screw
Connect the CloudLink 4G M1Modem antenna using
a wrench with torque 4-6 IN-LB
Connect the serial cable (RS232) from the CloudLink
Modem to terminal block of MiWwireless* (Do not
connect into RS485 slot)
Connect the power supply cables from the terminal
block as shown in the figure. Red wire to EXT-PWR
pin and Common to any one of the pins
* When there is a Protocol Translator board connect the serial cable (RS232) from the PT board to the CloudLink Modem.
Note : For information on retrofit kit details, please refer the document# 22-3015 & 22-3170.
Install the 4G antenna on the MiWireless
device by tightening the nut
Screw the mounting bracket onto the
Pivot/Sub panel to hold the Modem
Remove the existing 3G antenna
