COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
High (3)
Medium (2)
Low (1)
USE & OPERATION (CONTINUED)
REMOTE CONTROL
FUNCTION BUTTONS (CONTINUED)
2
: ON / OFF
: Controls cooling or fan option
: Controls the motion of the louvers
: Controls the Timer function for automatic shut off
: Switch between Normal, Random & Sleep
: Low / Medium / High
The remote control requires AAA (2 x 1.5V) batteries for replacement.
Open the battery compartment at the back of the remote control and insert the batteries inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
Do not mix old and new batteries.
Exhausted batteries are to be removed from the product.
•
•
•
•
•
•
•
•
Note:
POWER
COOL
SWING
TIMER
WIND
SPEED
SPEED
Press the SPEED button repeatedly to change the speed between 3 - 2 - 1.
The indicator light will show the selected speed:
WIND
Press the MODE button to select your desired wind type: N - R - S.
COOL
Press the COOL button until the COOL indicator light is illuminated on the control panel. This activates
evaporative cooling. The water pump will operate and you will feel the cooler air after the Honeycomb
Cooling Media is completely wet.
Note:
When the COOL indicator light is switched OFF, the unit can still function in a fan only mode
(without evaporative cooling).
You can select either High, Medium or Low fan speeds.
The fan speed alternates between High, Medium and Low and off to mimic a natural
breeze.
This mode is for comfort during the night. When SLEEP mode is selected, the airflow will
start at a higher speed for 30 minutes and reduce to a lower speed for 30 minutes. When
the speed reaches Low speed, the fan will run in low speed continuously until you switch
OFF the unit. You may set the starting speed to be High, Medium or Low. If you start the
SLEEP mode with High speed, the fan will run for 30 minutes in High speed, then 30
minutes in Medium speed and finally switch to Low speed continuously. If you start the
SLEEP mode with Medium speed, then the fan will run for 30 minutes in this speed before
changing to a continuous Low speed.
ON / OFF
COOL
SWING
TIMER
SPEED
WIND
NORMAL (N)
RANDOM (R)
SLEEP (S)
:
:
: