ACUIX Stick Mount Quick Installation Guide
Document 800-03542 – Rev A – 12/08
© 2008 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be
accurate in all respects. However, Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new
editions to this publication may be issued to incorporate such changes.
www.honeywellvideo.com
+1.800.796.CCTV (North America only)
Double Ball Joint Stick Mount (HDH6D)
Note
See
Figure 8
to complete this step.
1.
Screw the camera onto the 1/4”-20 tripod mounting screw. The nut
cannot be loosened and stays on the inside, closest to the ball socket.
2.
Grasp the bottom of the double pivot assembly and loosen it from the
base plate.
3.
Slide the mount within the two slots to position the camera based on
the installation requirements.
4.
Loosen the angle adjustment knobs. Adjust the camera to the required
angle.
5.
Tighten all connections and complete the wiring as per the camera
selected.
Figure 8
Double Ball Joint
5
Install the Lower Dome
1.
Clip the lower dome lanyard to the housing bracket. See
Figure 7
.
2.
Confirm that the o-ring is in place around the lower dome.
3.
Press the lower dome into the housing and turn the screws to secure
the lower dome to the housing.
Camera mount
screw (1/4“-20
tripod)
Base plate slots -
bi-directional
Double ball joint assembly - loosen at
base to adjust camera location
Angle adjustment knob (1 of 2)
