ACUIX
TM
ES Fixed Camera Installation Guide
Document 800-02848 Rev C
19
03/2009
Step 4: Install the PCB Board Cover
Note
The purpose of the PCB board cover is to prevent anyone from seeing the
inside of the camera from the ground. It is used for all installations.
1.
Align the open side of the PCB cover with the camera block (which includes the lens
and green PCB board) using
as a guide.
2.
Start at the monitor out side of the camera block and slide the PCB cover towards the
two adjustment pots.
3.
Adjust the PCB cover to be under the lens levers and on top of the monitor out.
Figure 10
PCB Board Cover Installation
Monitor Out
Adjustment Pots
PCB Cover
Slide the PCB cover onto the camera block from the side
with monitor out to the side with the adjustment pots
Levers
The lens levers remain on
top of the cover
Monitor Out (under
the cover)
