Universal Vehicle Power Supply Installation Instructions
11
5
Put another 3/8-inch washer on the battery terminal post.
6
Slide the positive battery cable on the post.
7
Insert the post assembly (Steps 2 through 6) into the
positive battery terminal.
8
Tighten the battery terminal post securely.
9
Tighten the nut installed in Step 2 to secure the washers
and cables firmly in place.
10
Repeat Steps 1 through 9 for the negative wire.
11
Connect the ground wire. For help, see the next section.
Fasten the Ground Wire
The braided wire on the vehicle battery cable is the grounding
strap. To ensure proper cable shielding, fasten the ground
strap to the vehicle sheet metal.
1
Drill a small hole into the metal that you intend to fasten
the ground wire to.
2
Use a punch to dimple and enlarge the hole until it is the
same size as the screw.
3
Scrape off a small circle of paint around the hole to make
sure bare metal is exposed.
4
Secure the wire with a #8 5/8-inch screw and flat washer.
Power Connector Pin Assignments
The location of the pins for the CV31, CV41, and CV61 power
connector are the same, but the port pin assignments are
different. Non-regulated inputs require an external fuse.
CV31, CV41, and CV61 Power Connector:
The CV41 connector is
smaller in diameter than the CV31 and CV61 connectors.
1
2
3
4
5
6