HOLDUP
TRANSMITTER
DEVICE
MOUNTING
HOLE
COVER
SCREW
MOUNTING
HOLE
COVER
ATTACH
HOLE
TRIGGER
INSIDE VIEW
WITH
CIRCUIT BOARD
RESET
KEY
COVER TAMPER
RELEASE SWITCH
3V
LITHIUM
BA
TTER
Y
+
MOUNTING
HOLE
MOUNTING
HOLE
5869-001-V0
COVER
SCREW
COVER
ATTACH
HOLE
BREAKAWAY
TAMPER
RELEASE TAB
SCREW
HOLE
Figure 1
ORDERING
5869
Hold-Up Switch/Transmitter
5869
HOLD-UP SWITCH/TRANSMITTER
Mount the 5869 under a counter or
money drawer for easy access by the
cashier. Refer to the steps and figures
that follow for typical mounting
instructions. Before mounting the 5869
permanently, perform Go/No Go tests
to verify adequate transmitter signal
strength at desired mounting location
(refer to the Security System Control
Panel Installation and Setup Guide).
1. Remove the two screws (Figure 1)
securing the cover to the 5869 case.
NOTE: The holes located in the opposite corner
to the screws that secure the cover to the case,
provide a means for securing the transmitter to
the counter or drawer.
2. Using the case as a drill
template, position the case
in the desired location.
3. Drill a 1/16
"
pilot hole at the
breakaway tamper release
hole and the two case mounting
holes (Figure 2).
4. Attach the case to the counter or
money drawer using one No. 6 x 3/4
screw (supplied) at the breakaway
tamper release.
5. Install the battery (see BATTERY
INSTALLATION/REPLACEMENT).
6. Secure the cover to the case with
the two screws removed in step 1.
7. Secure the assembled case to
the counter or drawer using the
two No. 6 x 2 mounting screws
supplied (Figure 2).
INSTALLATION
The 5869
Hold-Up
Switch/Transmitter
should be programmed as a 24-hour
silent zone type. Refer to the Security
System Control Panel Installation and
Setup Guide for programming
instructions.
• During programming of the control
panel, the 5869
Hold-Up
Switch/Transmitter should be treated
as “RF” (i.e., supervised RF) Type
• The 5869 is one closed input loop
zone (loop 1)
Battery Installation/Replacement
1. Remove and retain screws securing
the 5869 cover.
2. Observing correct polarity, insert the
battery into the battery holder.
NOTE: Use care not to bend the antenna while
attempting to install battery.
3. Re-install screws to secure cover
and/or assembly. Refer to Figure 1.
PROGRAMMING
+
5869-002-V0
+
MOUNTING
HOLE
TRIGGER
HOLE
TRIGGER
BREAKAWAY
TAMPER
RELEASE
RESET
KEY
COVER
TAMPER
RELEASE
SWITCH
MOUNTING
HOLE
COVER
SCREW (2)
No. 6X1/2
COVER
3V
LITHIUM
BATTERY
CIRCUIT
BOARD
COVER
ATTACH HOLE
COVER
ATTACH
HOLE
MOUNTING
SCREW (2)
No. 6X2
BREAKAWAY
TAMPER
RELEASE
SCREW HOLE
INDEX
TAB
+
COVER
SCREW
NOTE
CIRCUIT BOARD REMOVED
FOR CLARITY ONLY. DO NOT
REMOVE CIRCUIT BOARD
DURING INSTALLATION.
Figure 2
