5
MOUNTING KIT
For extra security, you may want to permanently secure your safe to the floor. Pre-drilled holes for
this purpose are located on the bottom of the safe. While it is not extremely difficult to mount the
safe, it is important that you have the proper tools and knowledge to do so. If not, then you might
choose to utilize the services of a professional.
1.
Unlock the safe and Pull the drawer out until it stops. On each of the drawer glides there is
a small plastic latch. To remove the drawer you need to simultaneously push down on the
right side latch while pulling up on the left side latch putting forward pressure on the
drawer as you do. This will release the drawer from the drawer glides and allow the drawer
to be removed.
2.
Select a suitable and convenient location.
3.
If safe is being mounted to a wood floor, then it can be secured using at least two or more
of the bottom pre-drilled holes. Lag screws and washers should be used to secure in
place.
4.
If safe is being mounted to a concrete slab, then after determining placement, mark the
hole positions and set the safe aside. A mortar bit will be required to drill holes into the
concrete and masonry anchors used to secure in place.
5.
Once safe is properly mounted, replace the drawer by positioning back onto the drawer
slides and closing.
It is important to note that if prior to installation you have any questions and/or concerns regarding
the proper securing of the safe to a wall or floor you should check with your local home center /
hardware retailer or independent contractor. The securing of the safe to a wall or floor is at the
consumer’s expense and discretion. LHLP, Inc. is not responsible for any costs incurred if the unit is
damaged and needs to be replaced.
