Honeywell 3-144, Руководство по установке

Страница: 62 / 90

Galaxy 3 Series Installation Manual
5-4
Configuring as a Stand-Alone MAX
3
1. Ensure that the MAX
3
is connected to the Galaxy ( RS485 AB line ) and the MAX mode is enabled
(option 63.2.1 = OPTIONS.MAX.MAX Mode ).
2. Select option 63.2.2 = OPTIONS.MAX.MAX Address and press the ent key; the Galaxy
searches for the MAX
3
with the highest address (the new MAX
3
reader). The Galaxy panel may prompt
(depending on model) for the AB line (1 – 4) that is to be searched; select the line and press the ent key.
On locating the MAX address, the keypad prompts for the
OPERATING MODE
of MAX to be assigned:
select 1 = Standalone and press the ent key. The MAX
3
reader is readdressed as 32 .
When the reprogramming is complete the MAX
3
bleeps, LED 3-7 on the MAX
3
switches on and the keypad
display returns to 2 = MAX Address .
3. Disconnect the AB line from the MAX
3
reader. Ensure that all other modules (keypads, RIOs and on-line
MAX
3
readers) are still daisy-chained into the Galaxy panel. If the MAX
3
reader is the last module on the
AB line , remove the 680
Ω
end of line resistor and put it into the last module on the line.
4. The MAX
3
reader is now programmed as a stand-alone module in sleep mode (LEDs 3–7 on) and can
be programmed using the MAX
3
cards (refer to Programming Stand-Alone MAX
3
Readers).
Figure 5-3. MAX
3
LED’s
Configuring MAX
3
(cont’d)
x
P
MAX
3
1 = Read (Amber)
2 = Open (Green)
3 = Closed (Red)
4 = Nightlock (Red)
5 = Add (Red)
6 = Void (Red)
7 = Program (Red)