For your convenience, we have included 4 “AA” batteries that provide the power for the electronic
locking system. These batteries must be installed before using your safe. The battery compartment is
located inside the safe on the lock cover panel.
1. Remove battery compartment cover and insert 4 “AA” batteries (included). Make sure that the
batteries are installed in the correct direction with regard to polarity (+ and -). (Figure 1 & Figure 2).
2. Proper installation of the batteries will cause the keypad to beep once, the red and green LED lights
will flash twice and the keypad back light will flash once (Figure 3).
3. Replace the battery cover (Figure 4).
4. Proceed to the
“Testing Digital Lock” section on next page.
2
INSTALL BATTERIES
OVERRIDE ACCESS KEY
Your safe is equipped with an override access key which allows immediate access in case you forget
your user codes or the batteries need to be installed or replaced.
1. Remove override access rubber lock cover (Figure 1).
2. Insert the override access key into the lock until it stops (Figure 2).
3. With the key inserted turn clockwise to the right (Figure 3).
4. Turn the door handle upwards counterclockwise and pull the safe door open (Figure 4 & Figure 5).
Important: If the handle will not turn upwards counterclockwise, first turn the handle slightly back
to the left until it stops, then turn upwards counterclockwise again to open.
5. Remove override access key and store it in a safe place away from the safe. Replace the
cover over the key lock and proceed to
“Install Batteries”.
Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
Figure 4
Figure 4
Figure 5
