Honeywell 10260A Series Скачать руководство пользователя страница 4

Страница: 4 / 5

Page 4 of 5

62-86-33-41

Step Action

Calibrate the potentiometer.

Connect a multi meter set to ohms (

Ω

) to terminals TB4-35 & TB4-36.

Use a small allen wrench in the hole on the potentiometer actuator sleeve to turn the potentiometer.

Adjust the potentiometer to 500

Ω

+/- 5

Ω

Install the set screw.

When the potentiometer is set for 500

Ω

tighten the set screw.

Replace the gasket.

Re-attach the top cover.

Содержание 10260A Series

Страница 2: ...ntiometer wires at the terminal board Terminals 32 33 34 35 36 and 37 Disconnect potentiometer from mounting plate Save the nuts for next step 3 Mount the new potentiometer using saved nuts 4 Slide the potentiometer actuator sleeve through the potentiometer and over the end of the cam bushing Push the sleeve in potentiometer fitting the pin into the slot of the potentiometer ...

Страница 3: ...ity Connect the potentiometer wires to the appropriate terminals using the wiring table below Wire Color Terminal Red TB4 32 Blue TB4 33 Green TB4 34 Black TB4 35 White TB4 36 Yellow TB4 37 6 Position actuator to 50 of span Pointer may be on either the right or left side of the scale Pointer as shown is on the left side of the scale ...

Страница 4: ...s Ω to terminals TB4 35 TB4 36 Use a small allen wrench in the hole on the potentiometer actuator sleeve to turn the potentiometer Adjust the potentiometer to 500 Ω 5 Ω Install the set screw When the potentiometer is set for 500 Ω tighten the set screw 8 Replace the gasket 9 Re attach the top cover ...