10
Mounting and Connection Instructions TouchCenter Keypad BUS-2
Do not use aggressive or plastic decomposing liquids e.g. petrol, turpentine, thinner, etc.
Aggressive cleaning agents may damage or discolour the surface.
Do not use abrasives, e.g. scouring agents, scour pad.
Clean with a soft, moist cloth.
Only use clear water.
2.1 Information for cleaning
To prevent accidentally starting any operating process, briefly disable the touch function before
cleaning the device. Select the menue “Further functions” -> “Clean display”. The touch function
will be disabled for 30 seconds.
2. Cleaning and care
1. Safety instructions
Please read these instructions carefully and completely before installing and starting to work with
this unit. This manual contains important information on installation, programming and operation.
The unit has been built in accordance with state-of-the-art standards. Only use the unit:
- according to the designated use and
- in technically perfect and correctly installed condition
- according to the technical data.
The manufacturer cannot be held liable for damage resulting from use contrary to the designated
purpose.
Installation, programming, maintenance and repair works must be carried out only by authorized
trained persons.
Soldering and connecting works on the entire system may only be carried out when disconnected
from mains. Soldering works must only be performed with a temperature-regulated soldering iron
galvanicaly separated from the mains.
The safety regulations by VDE and the prescriptions of the local electricity supplier have to be
observed.
The operating unit must not be used in explosion endangered environment
or in rooms with metal- or plastic-decomposing vapours.
Operator guidance is via the touch screen. If no inputs are made during operation, the screen
switches to the basic state and the backlighting is deactivated after the programmed operating time
(central control unit). Touch the screen with a finger to re-activate the display lighting.
The screen switches to the basic state and the backlighting is deactivated after the programmed
operating time (central control panel), however 15 minutes the latest.
Attention!
Do not operate the touch panel (surface of the screen) with sharp or
rough objects!
3. Important operating information
