FEDERAL COMMUNICATIONS COMMISSION (FCC) & INDUSTRY CANADA (IC) STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or
modifications could void the user's authority to operate the equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, as defined by FCC Rules Part 15.105. The Class B Digital Device
statement can be viewed at:
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules, and Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC et exempt de licence RSS d’Industrie Canada. Son fonctionnement est soumis aux conditions suivantes:
(1) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences causant une réception
indésirable.
RF EXPOSURE WARNING
– The antenna(s) used for this device must be installed to provide a separation distance of at least 7.8 inches (20 cm) from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
Mise en Garde Exposition aux Frequences Radio:
L'antenne (s) utilisée pour cet émetteur doit être installée à une distance de séparation d'au moins 7,8 pouces (20
cm) de toutes les personnes.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING
LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
Responsible Party / Issuer of Supplier’s Declaration of Conformity: Ademco Inc., a subsidiary of Resideo Technologies, Inc., 2 Corporate Center
Drive., Melville, NY 11747, Ph: 516-577-2000
The product should not be disposed of with other household waste. Check for the nearest authorized collection centers or authorized recyclers. The
correct disposal of end-of-life equipment will help prevent potential negative consequences for the environment and human health.
Any attempt to reverse-engineer this device by decoding proprietary protocols, de-compiling firmware, or any similar actions is strictly prohibited.
SUPPORT & WARRANTY INFORMATION
For the latest documentation and support, please go to:
For the latest warranty information, please go to:
www.security.honeywellhome.com/warranty
The Honeywell Home Trademark is used under license from Honeywell International Inc.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
2020 Resideo Technologies, Inc.
www.resideo.com
Ê800-25553BbŠ
800-25553B 5/19 Rev B
SPECIFICATIONS:
Smoke Detection:
..................................................................Photoelectric
Heat Detection:
......................................................................135° F (57° C) or g/- 5°F
Rate of Rise:
...........................................................................>104° F (40° C) @ 15° F/minute (8.33° C/minute).
dB Rating:
................................................................................>85dBA (Minimum) at 9ft
Batteries:
.............................................................................Two 3V Lithium; Panasonic CR123A, Resideo 466
RF Frequency:
........................................................................2.4GHz
Tamper:
....................................................................................Base Tamper
Operating Temperature:
.......................................................40° to 100° F / 4.4° to 37.7° C
Relative Humidity:
..................................................................15% to 95% max, non-condensing
Maximum Spacing:
........................................................50ft x 50ft (refer to National Fire Alarm Code Standard NFPA 72 for application requirements)
Dimensions:
...........................................................................4.5 in. Diameter x 1.7 in. Thick / 11.9 cm Diameter x 4.5 cm Thick
APPROVAL LISTINGS:
FCC / IC
ETL Listed – Conforms to UL 268 7
th
Edition
cETL Listed – Certified to
UL268 & CAN/ULC S529
Other Standards: State of California requirement – free of substances that may cause cancer. Prop 65 US.
NFPA 72
NOTE
: Smoke detectors are not to be used with detector guards unless the combination is evaluated and found suitable for that purpose.
