– 1 –
LTE-21V Module Kit – Installation Instructions
General Information
The LTE-21V is an optional communication module intended
for use with the VISTA-21iPLTE and V21SIALTE controls,
and provide cellular radio communication with the AlarmNet
network for delivery of alarm and other messages to the
monitoring central station.
IMPORTANT!
Use of this module requires an AlarmNet-I account. If an
account for the control does not yet exist, please obtain
the account information from the central station prior to
programming this module.
This kit contains the following components:
ESD SENSITIVE DEVICE - To discharge any static buildup, briefly touch a chassis ground point before
installing this module. Avoid performing this installation while standing on a carpeted floor.
NOTE:
The module is supplied with the antenna adapter cables pre-connected to the module.
Installing the module
1. Mount the Module Board.
Disconnect power from the control, includ-
ing the battery, BEFORE installing the
module.
a. Carefully align the module board over the standoff holes
and the mating connector on the VISTA-21IPLTE or
V21SIALTE control. Then, gently push down on the
board near each standoff until it snaps into place and
the connector is fully seated.
b. After installation, affix the “Contains Transmitter
Module” FCC label to the outside surface of the control
panel cabinet so it is visible.
Installing the module on the
VISTA-21iPLTE/V21SIALTE PCB
