2
ATTENTION: MERCURY RECYCLING NOTICE
This product does not contain mercury.
However, this product may replace a product
that contains mercury. Mercury and products
containing mercury should not be discarded in
household trash.
For more information on how and where to
properly recycle a thermostat containing
mercury in the United States, please refer to the
Thermostat Recycling Corporation at
www.thermostat-recycle.org.
For mercury thermostat recycling in Canada,
please refer to Switch the Stat at
www.switchthestat.ca
N O M E R C U RY
Hg
Preparation for Installation
1. Before proceeding, first turn off power to the healing system at the main
fuse or circuit breaker panel. See warning note.
2. When replacing your old thermostat, remove the two mounting screws of
your old thermostat and pull out of the junction box.
3. Label the wires in the junction box, so that they match the thermostat
wires to which they are attached.
4. Disconnect the old thermostat.
Wiring and Installation
1. When installing your new thermostat, remove the prestripped insulation
tips from your new thermostat´s leads.
2. Re-connect wires in the junction box to matching leadwires on back of
the thennostat. See wiring diagram below. NOTE: Do not connect power
supply LI-L2 to L1-TI, to avoid thermostat burn - out.
CAUTION
Use certified soIderless wire connectors (not included) approved for
No. 12 wires and tighten them firmly so they cannot be pulled off.
Failure to tighten firmly may cause overheated connection.
3. Remove thermostat cover.
4. Mount the thermostat to the junction box using two capitive screws
provided. Do not press the knob or bimetal sensing element during
mounting.
5. Replace the thermostat cover.
