ADEMCO 5828DM
5828/5828V Desk Mount
Installation and Setup Guide
GENERAL INFORMATION
The 5828DM Desk Mount Kit allows the end user to place the 5828 or 5828V wireless keypad in a convenient location
such as on a bedside table. The keypad can be powered by battery or by AC using the AC Adapter. The keypad is
shipped with a wall-mounting plate that is not required if using the Desk Mount Kit. The Desk Mount contains four rubber
feet to prevent slipping or scratching of sensitive surfaces.
Dressing the Wire Breakout
I
f you want the AC Adapter wires to exit from the left, right, or bottom
of the keypad
when the keypad is mounted, refer to
Figure 1. Note that the AC Adaptor connector is inserted into the mating keypad connector input
before
attaching to the
Desk Mount. Dress the wires in the desired direction in the slots provided.
Installing the keypad on the Desk Mount
If you want the AC Adaptor wires to exit left, right, or back
of the Desk Mount
, attach the keypad to the Desk Mount first.
(Attach the keypad to the Desk Mount by positioning the keypad over the Desk Mount and slide down, engaging the four
retaining clips on the Desk Mount with the four mating receptacles on the keypad as shown in Figure 2.
5
8
2
8
D
M
-0
0
-0
0
1
-V
0
AC
ADAPTOR
CONNECTOR
INPUT
RETAINING CLIP
RECEPTACLE (4)
Figure 1. Connecting the AC Adapter
(Note wire dressed to exit keypad on
right side after mounting.)
5
8
2
8
D
M
-0
0
-0
0
2
-V
1
DESK MOUNT
ARM
ED
REA
DY
MIC
MESS
AGE
RETAINING
CLIP (4)
AC ADAPTOR
WIRE CUTOUT
(3)
Figure 2. Attaching the keypad to the Desk Mount
If it is desired to have the AC Adapter wires exit through the Desk Mount, first refer to Figure 2 and attach the keypad to
the Desk Mount; then connect the AC Adapter as shown in Figure 3.
