Honey Bee Grain Belt Plus 3055, Руководство оператора

Страница: 245 / 253

Honey Bee Manufacturing Ltd.
2007 Grain Belt Plus Supplement
If the sensor arm is too close or rubs on the
sensor mount, it may be necessary to install one
or more spacers (washers) behind the rod
locking collar. Do this by first loosening the bolt
on the inside of the sensor mount, then
removing the rod locking collar. Next add
spacer(s) into the pocket behind the locking
collar, and re-assemble. Re-check the
alignment and spacing between the sensor rod
and sensor arm.
Ensure the sensor rod is free to move through
the slot in the front sensor mount. If it is not
moving freely, the sensor rod, sensor mount or
sensor arm may be bent; or too many or too few
spacers may have been installed in the previous
adjustment.
Ensure you have a good line of sight down the
link arm to the sensor arm. Some adjustment of
the sensor arm may be required, and is
acceptable, so long as it does not cause the
voltage range to exceed the established limits.
Rev. 01 - 04/25/08 24
Adding or Removing Spacers