Honest AUF-4210-0000X, Руководство пользователя

Страница: 3 / 24

3 Rev. 8 10/20
OWNER INFORMATION (CONT.)
IMPORTANT SAFETY INFORMATION
•
Review the owner's manual prior to using the
water filtration system.
• Install the system for its intended use as out-
lined in this manual.
• Do NOT operate the system if the cord or plug is
damaged; if it is not working properly, or if it has
been damaged or dropped.
• Only qualified personnel should service the sys-
tem.
• Do NOT allow the cord or plug in water.
• Do NOT allow the cord near heated surfaces.
• Only use this system with cold water.
Carefully observe the following warnings and cau-
tions, which appear throughout this manual.
•
Unplug the power cord before servicing this sys-
tem.
• Follow all local electrical codes and any other
applicable codes with all electrical connections.
• Install a ground fault circuit interrupter (GFCI)
on the circuit to this system.
• Do NOT modify the power cord. If necessary,
contact a qualified electrician.
• Do NOT use an extension cord.
• If the power cord is damaged, contact the man-
ufacturer, its service agent, or a similarly quali-
fied person.
• Follow all local plumbing code and any other ap-
plicable code when installing the system.
• If the system is installed on metallic plumbing,
an electrical bonding jumper must be installed
across the inlet and outlet pipes.
• Water pressure must not exceed 100 psig (690
kPa). If necessary, install a water pressure regu-
lator.
• If the inlet water pressure is less than 50 psig
(345 kPa), install a booster system.
• Do NOT allow the trans membrane pressure
to exceed 45 psi (310 kPa). Trans membrane
pressure is the pressure differential (delta) from
the influent side of the membrane wall to the
effluent side on the membrane wall.
• Protect the ultrafilter from becoming dry by
keeping it wet and sealed at all times.
• Do NOT allow the ultrafilter to freeze during op-
eration or storage to avoid damage.
• Do NOT allow long-term exposure to direct sun-
light or other UV sources.
• Avoid any sudden changes in operating tem-
perature. Make any changes to the operating
temperature slowly.
• Do NOT drop or bump the system to avoid dam-
age or breakage of the filter. Be sure to handle
carefully during transportation and installation.
• Do NOT use strong solvents containing chlo-
rine, or concentrated acids on the ultrafilter
membrane.
• Do NOT use strong solvents or concentrated
acids on the plastic parts of the system, which
includes acetone, methyl acetate (nail polish
remover); hexane (spot removers); turpentine,
toluene (paint thinners); dry cleaning solutions,
insecticides.
• Flush all pipes before installing the system. Any
abrasive materials can cause irreversible dam-
age to the membrane.
• Do NOT use sharp objects, like knives, sandpa-
per, or other tools on the plastic parts of the sys-
tem. A cut or nick on a plastic part can weaken it
and cause a leak.
• Do NOT use abrasive cleaners on plastic parts.
• Protect the system from shock, pressure surg-
es, or pulsation that can occur in water pipes.
Use a water hammer arrestor to reduce pres-
sure shock on the inlet side of the the system if
necessary.