Tyre Puncture
u
Removing Wheels
90
Tr
ou
bles
hoo
ting
Installation
1.
Attach the side collar to the rear wheel.
2.
Place the rear wheel between the
swingarm and install the drive chain over
the rear wheel sprocket.
3.
Make sure that the lug on the swingarm
is located in the slot of the brake panel.
4.
Insert the rear axle shaft from the left
side, through the left swingarm, wheel
hub, brake panel and right swingarm.
5.
Temporarily tighten the rear axle nut.
6.
Connect the brake rod to the brake arm.
7.
Adjust the drive chain slack.
2
P. 73
8.
Adjust the rear brake pedal freeplay.
2
P. 66
9.
Tighten the rear axle nut.
10.
After installing the wheel, apply the
brake pedal several times, then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Brake panel
Rear axle nut
Swingarm
Lug
Slot
Torque:
93 N·m (9.5 kgf·m, 69 lbf·ft).
