76
Troubleshooting
Tyre Puncture
u
Removing Wheels
Installation
1.
Install the side collar into rear wheel.
2.
Place the rear wheel between the swingarm
and install the drive chain over the driven
sprocket.
3.
Insert the rear axle shaft from the left side,
through the left swingarm, wheel hub and
brake panel.
4.
Temporarily tighten the rear axle nut.
5.
Reassemble the brake stopper arm and
tighten the stopper arm nut.
6.
Connect the brake rod to the brake arm.
7.
Adjust the drive chain.
2
P. 61
8.
Adjust the rear brake freeplay.
2
P. 55
9.
Tighten the rear axle nut.
10.
Reassemble the drive chain case.
2
P. 44
11.
After installing the wheel, apply the brake
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure
a fastener. Always replace a used cotter pin
with a new one.
Torque:
22 N·m (2.2 kgf·m, 16 lbf·ft)
Torque:
88 N·m (9.0 kgf·m, 65 lbf·ft)
Drive chain
Adjusting nut
Lock nut
Rear axle shaft
