www.powershot.co.nz
16.
TREAT FLUID INJECTION AS A SIMPLE CUT! See
a physician immediately!
DANGER! Carbon Monoxide. Using an
engine indoors can kill you in minutes. Engine
exhaust contains high levels of carbon
monoxide (CO), a poisonous gas you cannot
see or smell. You may be breathing CO even
if you do not smell engine exhaust.
%UHDWKLQJH[KDXVWIXPHVZLOOFDXVHVHULRXVLQMXU\
or death! Engine exhaust contains carbon monox-
ide, an odorless and deadly gas.
2SHUDWHSUHVVXUHZDVKHULQDZHOOYHQWLODWHG
area. Avoid enclosed areas such as garages,
basements, etc.
1HYHURSHUDWHXQLWLQRUQHDUDORFDWLRQ
occupied
by humans or animals.
WARNING! Risk of Fire, Asphyxiation and
%XUQ1HYHU¿OOIXHOWDQNZKHQHQJLQHLV
UXQQLQJRUKRW'RQRWVPRNHZKHQ¿OOLQJIXHO
tank.
1HYHU¿OOIXHOWDQNFRPSOHWHO\)LOOWDQNWR´
PPEHORZERWWRPRI¿OOHUQHFNWRSURYLGH
space for fuel expansion. Wipe any fuel spillage
from engine and equipment before starting
engine.
'2127OHWKRVHVFRPHLQFRQWDFWZLWKYHU\KRW
HQJLQHPXIÀHUGXULQJRULPPHGLDWHO\DIWHUXVH
of your pressure washer. Damage to hoses from
contact with hot engine surfaces will NOT be
covered by warranty.
NOTICE: Risk of property damage. Never pull water
supply hose to move pressure washer. This could
damage hose and/or pump inlet.
'2127XVHKRWZDWHUXVHFROGZDWHURQO\
1HYHUWXUQZDWHUVXSSO\RIIZKLOHSUHVVXUHZDVKHU
engine is running or damage to pump will result.
'2127VWRSVSUD\LQJZDWHUIRUPRUHWKDQWZR
minutes at a time. Pump operates in bypass mode
when spray gun trigger is not pressed. If pump is
left in bypass mode for more than two minutes in-
ternal components of the pump can be damaged.
If you do not understand these precautions, please
contact our customer service department at www.
powershot.co.nz
Prior to starting, refer to your engine manual for
proper starting procedure.
1. In a well ventilated outdoor area add fresh, high
quality, unleaded gasoline with a pump octane
UDWLQJRIRUKLJKHU'RQRWRYHU¿OO:LSHXS
spilled fuel before starting the engine. Refer to
Engine Owner’s Manual for correct procedure.
NOTE: Do not use fuels with a percentage of
ethanol that is greater than 10%.
2. Check engine oil level. Refer to Engine Owner’s
Manual for correct procedure.
3. Check pump oil level. The oil level should come to
the dot in the middle of the sight glass. Refer to
the Pump paragraph under Maintenance.
&RQQHFWWKHZDWHUKRVHWRWKHZDWHUVRXUFH7XUQ
the water source on to remove all air from the
hose. When a steady stream of water is present,
turn the water source off.
9HULI\WKH¿OWHUVFUHHQ2LVLQZDWHULQOHWRI
pump. (See diagram on following page)
NOTE: Convex side faces out.
6. Connect water source (N) to pump inlet (J).