6 of 8
AII 27857 (0408)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
CENTER
PANEL
SELF-TAPPING
SCREW
(Discard.)
SELF-TAPPING SCREW
(Discard.)
40 mm
40 mm
RUBBER
PAD
ADHESIVE BACKING
CENTER PANEL
RUBBER PAD
(Cut.)
END OF CURVE
RIB
Thoroughly clean
with isopropyl
alcohol.
10. Remove the center panel:
•
Remove the two bolts from the bottom of the
center panel.
•
Reach through the bottom opening, and push
out on the center panel bracket to release the
nine clips.
•
Unplug the five connectors and the antenna
lead, then remove the center panel.
CENTER
PANEL
RETAINING
CLIPS (9)
ANTENNA
LEAD
BOLT
CENTER
PANEL
BRACKET
VEHICLE HARNESS
CONNECTORS (5)
Push.
11. Gently pull out on each knob to remove them from
the heater control panel.
12. Remove the three self-tapping screws that fasten
the heater control panel to the center panel, and
remove the heater control panel.
CENTER PANEL
SELF-TAPPING
SCREW
HEATER
CONTROL
PANEL
KNOB
13. Remove the pocket (four self-tapping screws).
14. Use a tape measure to measure and mark the
rubber pad as shown. Using scissors, cut the
rubber pad into three pieces. Remove the adhesive
backing from each of the rubber pads, and attach
them to the center panel in the areas shown.