Honda NC700 2012, Руководство по обслуживанию

Страница: 515 / 773

14-24
dummyhead dummyhead
CRANKCASE/TRANSMISSION/BALANCER
• Coat each gear with clean engine oil and check for
smooth movement.
• Align the lock washer tabs with the spline washer
grooves.
• Always install the thrust washers and snap rings with
the chamfered (rolled) edge facing away from the
thrust load.
• Install the snap rings [1] so that the end gap aligns
with the groove of the splines.
• Make sure that the snap rings are fully seated in the
shaft groove after installing them.
INSTALLATION
MAINSHAFT/COUNTERSHAFT
Install the mainshaft assembly [1] into the upper
crankcase.
Apply engine oil to the right mainshaft bearing [1].
Install the right mainshaft bearing into the upper
crankcase.
Install the bearing into the crankcase with the marked
side facing out.
Apply locking agent to the mainshaft bearing set plate
bolts threads (page 14-6).
Install the mainshaft bearing set plate [1] with its "OUT
SIDE" mark [2] facing out.
Install and tighten the mainshaft bearing set plate bolts
[3] to the specified torque.
CORRECT INCORRECT
[1]
[1]
[1]
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
[3]
[1] [2]